The LX-7 is a stylish, high-performance passive loudspeaker, custom-built in Australia for screen sizes 75 inch and above.
Featuring left, centre and right channels, it can be combined with surround speakers and an AVR/processor to create a genuine, immersive cinema soundscape without the need for virtual or ‘bouncing’ effects. The sleek design requires minimal space above or below your screen. The LX-7 is intended to be combined with a Krix subwoofer(s) to accurately reproduce the lowest frequencies for the very highest level of home cinema performance.
Using the included bracket, the LX-7 can be mounted flush against the wall or at adjustable angles up to 15 degrees for optimal sound dispersion.
The LX-7 is tonally matched to all Krix surround and overhead speakers.
Three 90 x 90 Krix short throw waveguides significantly improve dispersion characteristics and increase efficiency for very high output levels
It’s not a sound bar… it’s a sound experienceSPECIFICATIONS
60Hz-20kHz in room response
50-250 Watts RMS recommended amplifier power
92dB for 2.83 volts at 1 metre
Bass reflex, front vented, 12mm braced MDF
Various – see specification sheet
Low frequency driver
Single 165mm (6 1/2”) paper cone. 50mm (2”) voice coil wound on high powered kapton former, with ventilated spider and aluminum flux stabilisation ring for low distortion
High frequency driver
26mm (1”) doped fabric dome with large roll surround. Ferro fluid cooled. Coupled to a Krix designed 90 x 90 short throw waveguide
High current terminals featuring 5mm hole to accept up to 10 AWG cable
Various – see specification sheet in photos
Cinema Black with grille and bracket
LX-7 CL (custom length between 1670mm – 2260mm)
Room Design Service
Have the cost of your room design deducted from any equipment purchased
Ask our friendly team about our installation service
Visit Our Showroom
121 Brunswick St, Fortitude Valley, Brisbane QLD 4006